[PEDA] Many similar Sheet Symbols

[Dennis Saputelli]

as far as i know, no
because the symbols would all point to the same file name

i think there is a method in 99SE for it to auto generate all the sheets 
from the first one but frankly i can't remember for sure, should be in 
the docs i guess

the problem i remember is that corresponding parts in each repeated 
section were not annotated logically

Dennis Saputelli

_______________________________________________________________________
CONTACT INFORMATION:
_______________________________________________________________________
Integrated Controls, Inc.           Tel: 415-647-0480  EXT 107
2851 21st Street                    Fax: 415-647-3003
San Francisco, CA 94110             www.integratedcontrolsinc.com
_______________________________________________________________________
NOTE! TO PASS OUR SPAM FILTER PUT THE FOLLOWING IN SUBJECT LINE: I.C.I.


Jakub M. wrote:
> Well, assume that AD6 is far away from horizon of my possibilities... :)
> 
> I have put 20x Symbols to main schema and changed symbols' names and now 
> the problem is to generate appropriate netlist and then user my pre-made 
> PCB. Is that possible?
> 
> 
> Dennis Saputelli napisał(a):
> 
>  
> ____________________________________________________________
> You are subscribed to the PEDA discussion forum
> 
> To Post messages:
> mailto:PEDA at techservinc.com
> 
> Unsubscribe and Other Options:
> http://techservinc.com/mailman/listinfo/peda_techservinc.com
> 
> Browse or Search Old Archives (2001-2004):
> http://www.mail-archive.com/proteledaforum@techservinc.com
>  
> Browse or Search Current Archives (2004-Current):
> http://www.mail-archive.com/peda@techservinc.com
>