[PEDA] Many similar Sheet Symbols

[Jakub M.]

Well, assume that AD6 is far away from horizon of my possibilities... :)

I have put 20x Symbols to main schema and changed symbols' names and now 
the problem is to generate appropriate netlist and then user my pre-made 
PCB. Is that possible?


Dennis Saputelli napisał(a):
> GET AD6
> :)
> it really handles this pretty well
>
> in 99SE there are methods but at the end of the day i found that you 
> really needed the 20 separate sheets
> and getting them to all annotate nicely was a major pain
>
> the 'repeat' feature was what finally drove me to AD6
>
> Dennis Saputelli
>
>
> _______________________________________________________________________
> CONTACT INFORMATION:
> _______________________________________________________________________
> Integrated Controls, Inc.           Tel: 415-647-0480  EXT 107
> 2851 21st Street                    Fax: 415-647-3003
> San Francisco, CA 94110             www.integratedcontrolsinc.com
> _______________________________________________________________________
> NOTE! TO PASS OUR SPAM FILTER PUT THE FOLLOWING IN SUBJECT LINE: I.C.I.
>
>
> Jakub M. wrote:
>   
>> [PROTEL 99 SE]
>>
>> In a device I want to put about 20 similar channels. Therefore I have 
>> made a schema of a channel and have put it to main schema as a Sheet 
>> Symbol 20 times. I have also made PCB for the single channel.
>>
>> Question:
>>
>> I want to generate netlist for the whole device and to use already made 
>> PCB of channel (the same for all channels). How to do this?
>>
>>
>> Regadrs,
>> JM
>>
>>
>>  
>> ____________________________________________________________
>> You are subscribed to the PEDA discussion forum
>>
>> To Post messages:
>> mailto:PEDA at techservinc.com
>>
>> Unsubscribe and Other Options:
>> http://techservinc.com/mailman/listinfo/peda_techservinc.com
>>
>> Browse or Search Old Archives (2001-2004):
>> http://www.mail-archive.com/proteledaforum@techservinc.com
>>  
>> Browse or Search Current Archives (2004-Current):
>> http://www.mail-archive.com/peda@techservinc.com
>>
>>
>>     
>
>  
> ____________________________________________________________
> You are subscribed to the PEDA discussion forum
>
> To Post messages:
> mailto:PEDA at techservinc.com
>
> Unsubscribe and Other Options:
> http://techservinc.com/mailman/listinfo/peda_techservinc.com
>
> Browse or Search Old Archives (2001-2004):
> http://www.mail-archive.com/proteledaforum@techservinc.com
>  
> Browse or Search Current Archives (2004-Current):
> http://www.mail-archive.com/peda@techservinc.com
>
>
>
>