[PEDA] Drill drawing graphic symbols

[Mario Irigoyen]

Hello Dom,

As stated in another email you are stuck using the Altium supplied drill
symbols, graphics...
There is a way to use your own although not automated (I suppose you
could create a script to do it):
Create graphical symbols on the pads in the footprint in your library on
a mechanical layer or the drill drawing layer then create your own drill
legend/chart with these symbols and hole details. This method is not
automated thus prone to errors, doable but not recommended. 

Mario Irigoyen
-----Original Message-----
From: peda-bounces at techservinc.com [mailto:peda-bounces at techservinc.com]
On Behalf Of Dom Bragge
Sent: Sunday, May 10, 2009 8:49 PM
To: PEDA
Subject: [PEDA] Drill drawing graphic symbols

I'm using AD6.9 on XPSP3

When configuring Gerbers - Drill Drawing to use Graphic Symbols, can I 
draw my own symbols to use instead of using internal altium supplied
ones?

Any ideas?

-- 
Regards,
Dom Bragge, CID+



____________________________________________________________
You are subscribed to the PEDA discussion forum

To Post messages:
mailto:PEDA at techservinc.com

Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com

Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/proteledaforum@techservinc.com

Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/peda@techservinc.com