[PEDA] Octagonal Pads

[John Echols]

All of the board houses we use send me pdf files of each layer for an OK
before they proceed.  I can look for any obvious D-code mistakes and any
special shapes I made to see if they came through as expected.

John Echols

-----Original Message-----
From: Terry Creer [mailto:tcreer at entechgroup.net] 
Sent: Tuesday, November 28, 2006 2:26 PM
To: dan_enslen at ti.com; 'Protel EDA Discussion List'
Subject: Re: [PEDA] Octagonal Pads

In addition to this, as I work at a manufacturer, I'm sure we'd be more
than
happy to do a check-plot of the artwork onto film for the customer to
check
the outputs prior to manufacture.

Far cheaper than 'suck it and see' board runs.

-----Original Message-----
From: PEDA-bounces at techservinc.com [mailto:PEDA-bounces at techservinc.com]
On
Behalf Of Dan Enslen
Sent: Wednesday, 29 November 2006 6:58 AM
To: 'Protel EDA Discussion List'
Subject: Re: [PEDA] Octagonal Pads

Good Afternoon All,
	I am not in the same position here as most, and I have
absolutely no
experience with Gerber readers, but it seems to me that it would be
quite
easy these days to make a prototype run to check out any radically new
or
questionable PCB structures. Granted, the monetary resources may
prohibit
this in a lot of cases. Just my 2 cents worth. 

Dan Enslen

The only reason time exists is so
everything doesn't happen all at once.


 
____________________________________________________________
You are subscribed to the PEDA discussion forum

To Post messages:
mailto:PEDA at techservinc.com

Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com

Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/proteledaforum@techservinc.com
 
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/peda@techservinc.com