[PEDA] Octagonal Pads

[Terry Creer]

In addition to this, as I work at a manufacturer, I'm sure we'd be more than
happy to do a check-plot of the artwork onto film for the customer to check
the outputs prior to manufacture.

Far cheaper than 'suck it and see' board runs.

-----Original Message-----
From: PEDA-bounces at techservinc.com [mailto:PEDA-bounces at techservinc.com] On
Behalf Of Dan Enslen
Sent: Wednesday, 29 November 2006 6:58 AM
To: 'Protel EDA Discussion List'
Subject: Re: [PEDA] Octagonal Pads

Good Afternoon All,
	I am not in the same position here as most, and I have absolutely no
experience with Gerber readers, but it seems to me that it would be quite
easy these days to make a prototype run to check out any radically new or
questionable PCB structures. Granted, the monetary resources may prohibit
this in a lot of cases. Just my 2 cents worth. 

Dan Enslen

The only reason time exists is so
everything doesn't happen all at once.