[PEDA] Many similar Sheet Symbols

[Peter Krause]

Jakub,

A suggestion.

What you can do is the following, it worked fro me in 99se

On the main sheet

Tools, Annotate, Reset all designators

Untick current sheet only

In advanced set the numbers you want allocated for each sheet( thus pcb)

Then annotate ?parts

This will annotate all parts uniquely

Then run design, create netlist, make sure you select, protel, netlabel and
ports global, active project.

Now this may take a few seconds or more, depending on your pc.

Load each premade pcb with preselected schematic numbers.

Load your netlist.

This should do the trick.

Best of luck.

Kind regards

Peter



-----Original Message-----
From: PEDA-bounces at techservinc.com [mailto:PEDA-bounces at techservinc.com] On
Behalf Of Jakub M.
Sent: Wednesday, 1 November 2006 5:50 AM
To: Protel EDA Discussion List
Subject: [PEDA] Many similar Sheet Symbols

[PROTEL 99 SE]

In a device I want to put about 20 similar channels. Therefore I have 
made a schema of a channel and have put it to main schema as a Sheet 
Symbol 20 times. I have also made PCB for the single channel.

Question:

I want to generate netlist for the whole device and to use already made 
PCB of channel (the same for all channels). How to do this?


Regadrs,
JM


 
____________________________________________________________
You are subscribed to the PEDA discussion forum

To Post messages:
mailto:PEDA at techservinc.com

Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com

Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/proteledaforum@techservinc.com
 
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/peda@techservinc.com



-- 
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.428 / Virus Database: 268.13.20/508 - Release Date: 31/10/2006
11:30 AM