[PEDA] pb short-circuit beetwen pad and internal plane with protel 99se

[Didier Fabbro]

for "label attached" i want to say that a net with an assigned name is
connected to the pad
yes this is the air gap...i see the same thing with a gerber viewer
solder mask expansion is different just circular shape
power plane connect show air gap and you can deduct conductor width
gerbers aren't differents with gerber viewer like GCpreview

thank you to try to understand my problem
it's national holidays for us
i'll read monday
have a nice we


-----Message d'origine-----
De : PEDA-bounces at techservinc.com
[mailto:PEDA-bounces at techservinc.com]De la part de Abd ul-Rahman Lomax
Envoye : jeudi 13 juillet 2006 16:16
A : Protel EDA Discussion List
Objet : Re: [PEDA] pb short-circuit beetwen pad and internal plane with
protel 99se


At 03:25 AM 7/13/2006, Didier Fabbro wrote:
>yes it's a 3,3 volts split plane and the pad in error is 24 volts
>i want to say that there are may other pad like this on the board...and why
>this pad ?
>the constraint for this pad is the constraint for all pads
>pads parameters : hole size 0,6mm x,y 1mm multilayer plated
>the plane clearance is 0,3mm
>the plane connect is 0,254mm for expansion width and gap
>when routing the 24v net i use a pad to go across the card
>and putting this pad on net it take automatically the name of the net!!

Yes, it does that. You can manually change it if you want, or if you
put a pad down *not* on a net, it will then be assigned No Net, and
that will not change if you move it.

You mentioned "label attached." What did you mean by that?

>visually protel shows the pad connected to 3,3v internal plane...i can see
>the air-gap arround the pad
>it's connected on the board...i have alas determined it!!!

Are you sure that you are seeing the air-gap? You might, for example,
be seeing solder mask expansion.

Have you looked at the gerbers? Are the gerbers different from what
the Protel display shows you?

(To check, load the relevant gerber file back to a Mechanical layer
in Protel. You can then view the mech layer and the protel split plan
together, using appropriate color combinations to make differences obvious.)



____________________________________________________________
You are subscribed to the PEDA discussion forum

To Post messages:
mailto:PEDA at techservinc.com

Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com

Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/proteledaforum@techservinc.com

Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/peda@techservinc.com

----------------------------------------------------------------------------
-----------
Orange vous informe que cet  e-mail a ete controle par l'anti-virus mail.
Aucun virus connu a ce jour par nos services n'a ete detecte.